How to Fix Garage Door Cable

A garage door cable is one of the safety mechanisms which are enhanced for any garage. This cable does the lifting deemed to be heavy when you lower or raise the door.

Your garage door requires maintenance and knowing how to fix problems that may arise increases the durability of your garage door cable.

A garage door cable serves various purposes such as:

• Protection against spring recoil;
• Accidents and damage prevention.

Steps One Can Follow Are:

If you are trying a DIY garage door repair near White Rock, begin by pulling the rope attached to your garage door opener. This will in turn release the opener from its drive chain. Once you notice the tension of the springs that raise the door becomes taught, you release the tension of this spring by lifting the door.

While doing this you have to disconnect the electricity from the door opener in case it is automatic. This will help you avoid any accidents.

Ensure safety precautions. Attach two c-clamps to the doors track just below the roller next to the door bottom part. These c-clamps prevent the door from falling.

Disconnect the cable running around above the doorway on your garage door frame. One end is wrapped around rollers while the other attached to a hook or clip.

Spot the frame with holes as it will help in disconnecting and reconnecting this end of the wire with at least one of the holes to prevent it from being loose.

Adjust cable. Use pliers to loosen the bracket that holds the wire to the hook if there is too much slack on the cable. While adjusting ensure you do not loosen the shaft too much to avoid them becoming tangled.

Tighten only until the slack is gone from the cable. Do not overdo this or under do it.

After replacing the cable examine the part which helps in balancing the garage door as well as where the cable is neatly wrapped. Ensure cable isn’t unwrapped on either side of the door, and both cables are properly and neatly aligned.

Once you confirm this you can go ahead and remove the clamps from the tracks of the garage and manually lower the door.

It is also important for one to know when it’s time to fix or replace your garage door cable.

When the cable shows signs of wear and tear, and this affects the normal running of the garage door then this will need a replacement. If an old cable is a reason for the mishaps then it’s time to replace it. You should note however that replacing and repair of these cables might sometimes require a professional to do it.

Importance of Fixing Garage Cable

• Allows continuous extension that helps the springs operate;
• Prevents quick wearing out of the garage door springs;
• Garage door cable acts supplements springs and door tracks;
• Minimizes tension that the spring might endure while lifting.

While following the steps to fix your garage door cable one needs to take extreme caution to avoid accidents. You can also engage an emergency locksmith, just in case your lock mechanism fails.

In case of uncertainty, a professional opinion can be useful to help you come out with the best work as well as act as a learning and experience garnering opportunity.